View Single Post
Old 06-27-2012, 08:11   #12 (permalink)
Agunk Radical
Junior Member
 
Join Date: Sep 2007
Location: T-THINK cell
Posts: 10
Member: 588102
Status: Offline
Thanks Meter: 2
Tested for SPRD3 6800H

Welcome to use McnBox!
Selected COM7 COM6
Baud setting ...
Set Baud done
Initialize in progress ...
Checking data ...
Serial No. MCNxxxxxxxxxxxxx
Firmware V1.15
Checksum ED52-CABE
Software V3.30
Box Connected!
Ready working at COM7
[G:8 9 D-:3 D+:4 Up:12 Down:5] Apply to Box
Checking USB Serial port, wait...
SCI USB2Serial Port: COM8
Connecting, wait...
Phone Connected!
Info: SPRD3
Initialize boot12...
Boot Done.
Flash Type NAND (0)
Start Writing...Code
Write Done!
 
The Following User Says Thank You to Agunk Radical For This Useful Post:
 
Page generated in 0.09079 seconds with 6 queries