i have maxtron mg-223, i try to connect with MCN but its say "not found boot"
i cant do anything...please fix this MCN TEAM
Code:
Welcome to use McnBox!
Selected COM5
Baud setting ...
Set Baud done
Initialize in progress ...
Checking data ...
Serial No. MCN2010xxxxxxxx
Firmware V1.15
Checksum 3385-1DBE
Software V3.33
Box Connected!
Ready working at COM5
Scanning pin status,please waiting...
->.........................
Pin-status Scan Done
Scanning,waiting...
->@....@
Operation done, Pin detect out.
BOOT£º1
USB D-: 3 USB D+: 4 Spread
Press [ Save ] to save Pinout
Total expend 27 seconds
...
->#..
...
->#......
Not found "BOOT"
[G:8 9 D-:3 D+:4 Up:1] Apply to Box
If Scan other phone, please click [Stop]
Scanning,waiting...
->@...@
Operation done, Pin detect out.
USB D-: 3 USB D+: 4 Spread
Press [ Save ] to save Pinout
Total expend 21 seconds
...
->#..
...
->#.....
Operation done, Pin detect out.
BOOT: 10 set as oInvert
USB D-: 3 USB D+: 4 GND:8 9
Press [ Save ] to save Pinout
[G:8 9 10 D-:3 D+:4] Apply to Box
If Scan other phone, please click [Stop]
Checking USB Serial port, wait...
Time out or Port detecting error.
Scanning pin status,please waiting...
->.........................
Pin-status Scan Done
Scanning,waiting...
->=........
Operation done, Pin detect out.
BOOT : 1 USB D-: 11 USB D+: 4 VID:4305&PID:74B3
Total expend 62 seconds
[G:8 9 D-:11 D+:4 Up:1] Apply to Box
If Scan other phone, please click [Stop]
Scanning,waiting...
->=............
Operation done, Pin detect out.
BOOT : 6 USB D-: 3 USB D+: 4 Spread
Total expend 72 seconds
...
->#..
...
->#.....
Not found "BOOT"
[G:8 9 D-:3 D+:4 Up:6] Apply to Box
If Scan other phone, please click [Stop]
