c55 consume 0.03 A in standby

[misel]

new c55 ,,previous unlocked by removing resistor consume 0.03A in standby ,,I solder back resistor and unlock phone with griffin sie clip ,,then flash phone with new software ,,,after all of this I check current and after power up, current is 200mA ,,,then phone go after 1 min in stand by ,then phone cosume 30mA ,this is to much ,,,I know that stand by current is about 3-5mA ,,,PCB is checked under microscope ,,everything is clear ,,no oxide,no H2O ,, then I remove PA,,,same current 30mA,,, batery is empty after 15-20 hours ,,this is problem

any good idea is welcome

[legija]

Maybe phone has non original eeprom ?

Many of C55's have problem with DIALOG ic, but i am not sure that can be problem here. I have one C55 with "interminently dead" problem, it was originaly chinese phone, and converted to euro by someone who cheat my customers. After writing corect boot core all were ok.

[genocite]

press on the phone and check for some voltage on the earphone contact point, if some voltage happened to be leak to there, mean the dialog is broken and had to be replaced, i had some problem like this with C/A5X phone which has been using fake charger before