ERSERV 1.7 ' Failed to enter sp mode '

[ptkrf]

I have a problem:

I use Victor Levunliev cable for 17 digit IMEI for Ericsson GA628, but the new series is very hard to unlock
IMEI number is 520018-61-379938-9-05, Program version is 9901131158 & CXC125056
Hardware revision is: 99W15 KRC 114 278/40 R2E
This type oh phone is year 1999

Problem: When I start erserv 1.7 and check any command (not sp-unlock this tampered the pohone checked) the prog says
'Failed to enter sp mode' and the phon power up.

I tray to use with zulea ericload prg says 'error port set' and ericflesh prog says ' time out ...'

can you still help me

Manfred

[sc~micro]

I had the same problem once.
Try new cable.
Get schematics from 'mobile.8m.com'

[ptkrf]

thanks, but still don't work

Manfred

[Dalton]

Easy when you connect the phone and will enter the test mode you have to push the no buttom quick not hold it in 1 of a 10 pice of a sec.
If not check pin 9 it must have the 5V.
Dalton

[ptkrf]

Hi guys, thanks but the problem is the phone!
hardware interface and cable works great on older phones, even on phones manufactured in 99' but the IMEI number MUST be lower then 52****-61-******-*-**, ERSERV 1.3 (1.7...) works great, if IMEI start on number 490***, here is what hapend when use erserv:

Ericsson 6xx or 7xx detected
Enter TEST Mode ...
Failed to enter sp mode ...

then the phone power up

The only way for new phone to be accepted with erserv 1.3 or Zulea dos programs, must be TAMPERED, then the programs work fine !!!!

Who now how to make the phone TAMPERED if not accepted with erserv 1.3 or Zulea dos programs ?????

please help me....

thanks Manfred