Dear sirs,I have done the Eric cable that I have found on freegsm.net but it doesn't work,I can't use neither ericserv1.8 nor emma.Could someone help me on doing PC cable?
Best Regards.
I had much problems with erserv32 and Win98 - try the cable under win95 - also look again, if all is soldered right, also check the pinouts of the connector, also click on the right checkbox for the com-port you are using.
- Do you have looked into system environment, if there is no hw-conflict between the com-port you are using for the cable and other devices (IRQ´s)?
Ok I think to have solved the problem,perhaps the fault is on the adaptor that I use to com 2 that reduced the com from large to small....
Best Regards.
------------------