R220 and T100 strange problem after flashing with UST

[Lutfe]

Hi,

I have one T100 and one R220 and both have problems after using UST.. the t100 was to flash language pack and after that fone takes almost 20 seconds to turn on and it freezes. I already flash EPROM and still have the same problem.
The R220 was contact provider, after i fix i was using the fone and during a call fone freezes and i remove batery but after that fone doesn not turn on again... i can flash but fone still dead.
Can someone please help.
Regards

[VsH-GsM]

About R220, for sure it has problem in hardware ! if phone doesn't turn on after successfully flashing , so it has problem in hardware..

About T100, are you sure you have a T100 ? may be T108 ?

[Lutfe]

Hi,

Its T100...
about the r220 fone was in contact provider, i use the fone after fix with UST. But after fone freezes i remove out batery and after that fone does not turn on more.
regards.

[VsH-GsM]

about R220, repair contact provider, is done via changing parameters in eeprom, and that can not kill phone at all, even if you put a blank eeprom chip to phone, phone can power on , but in contact provider mode, so ust didn't kill your phone, your phone has problem in hardware.

about T100, which language pack you used? did you tried other language packs too?