View Full Version : Griffin clip testpoint for X60
to_deal_with
12-09-2003, 23:26
hi everyboyd, I have attached a foto, which one is the testpiont track to be cut? the blue one or the red one which is marked?
cuz by the red one, there is no track to cut or should i cut throuw the board?:confused:
thanx in advance
Hi someone have edited my test-point picture.Cut the red track .It is an inner layer track . Cut it near the curve.
I 've distributed this picture with my software or with my A60 /C60 loger.
BTW Free logs for C60 and A60 are available in logs section
to_deal_with
12-10-2003, 00:01
any way, thanx for the useful testpoint picture
thanx sst-gsm
@ SST-GSM
Is there any solution by logs for unlocking a60 sw.16XXXX?
And btw which is the best solutoin for unlocking a60?
Where can I download logger for Siemens a60 from?
@kkl
yes my loger supports A60.
you need test-point to use it.
loger can be found at my site.
there is a free logs offer for a limited time.
well ok it is a bit tricky. But it works when you'v already done it
Firts you have to open the phone then remove the iron plate on the back. The one below is the only one you have to remove. Then you take a stanley knife(i dunno the exact english word for it) or just a sharp razor blade. I prefer working with the stanley knife because it is harder than the razorblade. You better make the cut precisely where the wires bends. It is not a wire on the surface but it is a inner wire. So you do see it, but it is in the "plastic" . I don't cut it but just press it gently 1 milimiter or something
When that is done you can unlock your phone
SST-GSM: Email sent !!!!!!!