Please help me resolve this problem.

[svukov21]

Can someone teach me how to now what pic and eeprom my card have?

Please any information is welcome.


Thanks in advance.

[simemu]

To see if you have a PIC 16F877, use the ICProg with verification activated to write the SIM-EMU 6.01 flash file.
If it is correct, use the new SIM-EMU 6.01 Configurator to see which type of external EEPROM do you have.
If it is not correct, perhaps would be a 16F84 or FunCard.

Could you put a small photo of your card in a post ?

Regards

[svukov21]

It is GSM card from Croatian operator Cronet 219 01.My card is almost dead I mean it need to be clone because it's worn out.My card is first generation of Cronet's gsm cards and I have next (and also the last one made for Cronet) generation card witch have 32k write on it.


Please help me clone my card.

P.S. Can I just read pic and eeprom with ic prog from my original card and put it in newer one that have 32k write on it (if I dont want to have 9 phone numbers...)?
It's not problem if I need to have 9 numbers... to clone my card and all the rest things given by you.

Thanks in advance.

[simemu]

To make a clone you don't need to know which type of card you have.
You only need to extract the Ki and IMSI using a Phoenix reader (TE-21).
Also, if you need it, you can save th ADN, SMS and FDN data using the new SIM-EMU configurator.

Once obtained these data, you can proceed to make a clone configuring it using the previous data saved.

To know how to make the clone, read the SIM-EMU page, www.simemu.cjb.net and the info of this forum.

Regards

[svukov21]

Do you know or can you give me a link where I can find schematic for Phoenix reader?I have JDM program that I use with IC-Prog and I didn't have any problems with programing pics.I understand that writing eeprom on card is diferent than normal eeprom writing.

[simemu]

I don't know the schematic of Phoenix.
Find in this post for that info.

Regards

[OnOff]

You Can find that schematic on www.ic-prog.com site under the link "Supported programmer types"

[svukov21]

Can you tell me wich one is it?Is it fun-card programmer?

Thanks in advance.

[OnOff]

Can you tell me wich one is it?Is it fun-card programmer?

Thanks in advance.

In that site you can find the JDM programmer Sch. that is used to program the EEPROM. To program the PIC I use a TAIT programmer. I don't know what they call Fun-card programmer, I don't use it. I'm a begginer too.

[svukov21]

I think that programing EEPROM on gsm cards or on any card is not same like program single (single chip)EEPROMS because for programin EEPROMS on card it is need to program PIC and PIC will program EEPROM itself it is called "Through pic programing" and that is way we need phoenix programer that I'm building right now.


Please be free to correct me if I'm wrong.

[OnOff]

You're right. It happens because on the GSM card you don't have fisical access to all the EEPROM pins. So you have to use "Through pic programing" that is done by programming the PIC with a "Loader"... That's all in ICPROG website. I've sucessfully programmed the PIC but I could not program the EEPROM with my phoenix. Don't know why, probably because my ICPROG configuration. If you success let me know how.

[svukov21]

Right now I dont have time to play with this but when I success i will inform you.