be4 powers on when unlock is pressed

[shaider]

i try to use different softwares to unlock be4, but in all cases the phone powers on and doesn't unlock, i know my cable is good coz it can unlock be1 w/o problems, it has no external batt. pls help<br />thanks

[legija]

Chek prints inside the phone. In some cases RX or TX prints may be broken.

[sladjan_vasic]

use cable with external power,remove batery and use software albe4 mcomm 2001 (allbe4new2808) for v138, or alcatelbe1-be3-be4 eraser v.3.3 for older version<br />regards..Sladjan

[shaider]

can u email me the schematic thanks<br />shaider@mozcom.com

[Sonia]

Chek mail!

Regards<br />Sonia

[Mr_Skoku]

pls send cable sheme to mee too.

WBR <br />Mr_Skoku

[Unlock-DK]

Plz send the schematic to me

[shubrt]

Pls Send to Me.Thanx

shubrt@cmail.cz

[legija]

Idiots !

[shubrt]

very thank !!!

shubrt@cmail.cz

[HFP]

Yes..new virus ID10T.....Use cable with transistor..and try use different R in base.<br />WBR.<br />Peter

<FONT COLOR="#ffff00" SIZE="1">[ 29 January 2002 22:23: Message edited by: HFP ]</font>

[legija]

Stupid, stupid peoplez...<br />It's not in the cable !<br />It's in phone -<br />1.Versions after 137 have about 25% bad units.<br />1. Bad connector - BAD CONNECTION<br />2. Dirty prints or moister damage- BAD CONNECTION<br />3. And finaly, damaged prints BAD CONNECTION<br />Solution:<br />OPen unit,<br />1. Chek connenctor on phone - thight it if need,<br />2. Chek prints - with ohm meter<br />3. Clean all<br />Unlock, or what ever you need.

Coz i haved this very day same **** - language injection -<br />version was 138 04 - and phone powers up when connect is pressed -<br />And think hard ×ôťÍ{ť<br />maybe is some new ****ing SW ?<br /> OF COURSE IS NOT !<br />Just bad unit !

IDIOTS !