PDA

View Full Version : Maxon 3204, Help.

Demon_Ok
08-19-2001, 11:57
Hi.<br />Help me to unlock Maxon 3204.<br />After use unlock programm, phone say "SIM Lock phone blocked" generator for All Maxon 2 don`t work.

Thanks.
SpE
08-21-2001, 01:24
maybe something on this site?<br />?<br /><a href="http://www.maxontool.f2s.com" target="_blank">http://www.maxontool.f2s.com</a>

try eeprom solutions that will free you phone again =)

<br />SpE
Guest
10-03-2001, 05:10
2 Demon_Ok.<br />You have solved this question? At me the same problem. <br /> <img src="frown.gif" border="0">
Sekoel
10-03-2001, 13:06
You have to solder out the eeprom. Read the eeprom with PonyProg open the saved *.bin file with MAXON Unlock by EDDIsoft. Write back the unlocked file. Works 100%.You can read the eeprom trough a eeprom programmer and a program like PonyProg.<a href="http://www.maxontool.f2s.com/" target="_blank">SpE</a>

Regards,<br />Fallen <img src="rolleyes.gif" border="0">

[ 03 October 2001: Message edited by: Fallen ]</p>
Bogi
10-03-2001, 23:03
Here is 1000% working solution for all Maxon phones with physical eeprom.Read eeprom and write:380h-00,381h-00,382h-39Fh-FF.Solder eeprom in phone and enjoy.
Guest
10-04-2001, 06:00
Hi.<br />Thank all. The after unlock (380h-00,381h-00,382h-39Fh-FF) is no network. Version 1.26, May 2001. I nead some more advice.
alro
10-04-2001, 09:47
Dear friend, maxon 3204 is not a dual band only 900 mhz!!!!<br />Regards,<br />ALro
Guest
10-04-2001, 11:22
I know, that 900MHz. I need to switch to another SIM a card in same network. With old dump eeprom and SIM a card all good works.
alro
10-04-2001, 11:51
maybe you damaged yor phone with opening or with desoldering of the eeprom. Sorry Idon't know.<br />Regards,<br />Alro
hek
10-04-2001, 13:07
is it necessary to desolder eeprom.
Sekoel
10-04-2001, 13:21
As far as I know there is no cable solution. And for "Guest" unlock your *.bin file with MAXON Unlock by EDDIsoft. I tested it and it works 100% .

Regards,<br />Fallen <img src="rolleyes.gif" border="0">

[ 04 October 2001: Message edited by: Fallen ]</p>
hek
10-05-2001, 14:17
i want to say that is better to use Soic Clip.

<br />regards.
Sekoel
10-05-2001, 14:46
Yes it's necessary to solder out the eeprom because with eeprom on the PCB PonyProg can't read the it. So you must solder out the eeprom and the put it in the Soic Clip. It's not necessary to use a Soic Clip but it will work must efficient.

Regards,<br />Fallen <img src="rolleyes.gif" border="0">