View Full Version : Flashing Nokia 3310 with Griffin
How I can repair IMEI on 3310, phone displays "Contact Service". And how to load EEPROM with Griffin box?
If you have any information about that, please send to e-mail. avs_2003@front.ru
tanx.
sergo_zmeia
06-08-2004, 02:23
Run a test with eeprom tools 3.1 and 4.0..this wiil give U some points where to start..
Good luck!
Big8
MGT SOFTWARE
06-09-2004, 14:03
Dear All, I flashed the phone Model NHM-5,Phone was with the error of recording missed call , also restart after a second, I flashed it with full firmware but the problem still, now the phone cannot power, I tried again but writing MCU is very faster than normal, I tried to use Other Flashing tool i.e Nokia DCT3 VER.4.78, I got error message that (Flash erasing error(battery voltage is too low)
@ AVS32
just use flasher by rolis, Knok etc
@ MGT SOFTWARE
(Flash erasing error(battery voltage is too low)?
I think you have a hardware error is the phone Liquid damaged?
wbr
D. :D
DeltaGSM
06-09-2004, 21:24
Dear All, I flashed the phone Model NHM-5,Phone was with the error of recording missed call , also restart after a second, I flashed it with full firmware but the problem still, now the phone cannot power, I tried again but writing MCU is very faster than normal, I tried to use Other Flashing tool i.e Nokia DCT3 VER.4.78, I got error message that (Flash erasing error(battery voltage is too low)
your flash ic is damage, just replace & flashing again.
good luck..
regards