Test point need help

[cole]

Hi

Since I have problems with test point`s could somebody direct me how to connect it.I getting error massage from CDR "phone not found"
I have home made dongle with 40 pin housing Atmega.
I attach test point of x6.Please direct me where to connect blue,brown,orange,green on Atmega 40 pin housing.
(for example blue goes to pin 40 on Atmega via 100 ohm resistor)
I hope you understand what I need .

Thanks

[JOHN_BOY_06]

can you unlock any other sagem phones with your dongle. you may have to change the chip to a 44 pin atmega and use a75ohm resister.
john

[cole]

Hi

No I don`t need to change my chip to 44 pin. ;)
That is same thing but in diferent package. ;) ;) ;)

I didn`t try any else phone , this is first one.


Regards

[JOHN_BOY_06]

are you trying to solder wires onto the board or are u using the test jigs.
it may be the cable that you are using. check your diagrams and let me know.
john

[cole]

Hi

I`m using "soldering wires" solution.
I try today dongle with MC922 phone without TP.Everithing OK.

Regards