samx600

[sony_cky]

i have tw0 x 600 .phone becomes on and keypad not working..only working the on off button.i had flash the phone but it shows the same problem

[moobile mafia]

Hi
Sony Its Not Sw Fault It Is Hw Fault So Check On Hard Ware
Open The Set And Check Ribbion And Fix Again And Ear Piece
If Not Than Come On Key Pad Area There Is Little Restors Are Short ,just Out Or Replace Its Up To U And Dont Forget Reaply Do It Tell Me Bye
Strange Friend

[Aishur]

i have tw0 x 600 .phone becomes on and keypad not working..only working the on off button.i had flash the phone but it shows the same problem

Hi mates,

You have a hard problem. To have solution use search button for the keywords X600 KEYPAD.
The Search button is a powerful tool.

for your convenence read
http://forum.gsmhosting.com/vbb/showthread.php?
t=143912&highlight=x600+keypad (http://forum.gsmhosting.com/vbb/showthread.php?t=143912&highlight=x600+keypad)

Best regards,
Aishur

[nacerdz]

tray to change mic , and post result here pleaze.

[sony_cky]

Hi
Sony Its Not Sw Fault It Is Hw Fault So Check On Hard Ware
Open The Set And Check Ribbion And Fix Again And Ear Piece
If Not Than Come On Key Pad Area There Is Little Restors Are Short ,just Out Or Replace Its Up To U And Dont Forget Reaply Do It Tell Me Bye
Strange Friend i had tried that u had told.but it shows the same problem

[sony_cky]

Hi
Sony Its Not Sw Fault It Is Hw Fault So Check On Hard Ware
Open The Set And Check Ribbion And Fix Again And Ear Piece
If Not Than Come On Key Pad Area There Is Little Restors Are Short ,just Out Or Replace Its Up To U And Dont Forget Reaply Do It Tell Me Bye
Strange Friendfirst i changed all the resistors it not worked..but it automaticly worked...thanku..

[mohammad2004]

1-full eprom reset

2-full eprom and flash org program by ust pro

3-clean board good

4-remove the E62-E61

5-remove the 6 foot up cpu phone full : 1000000000000% ok

[CELL SOLUTIONS]

hello . need x600 charging solution regards

[SR-sigma]

hi
see this its helps u..................

[irfaN_vu]

hi sony .... just open ur X600 C below the antena there a ribben ....just clean it with rubber ...clean the board with CTC liqude .... and give some heat... and ur set is work 1000% fine.... its tested by me servral timesssssssss.....