X66 kept restarting as Power On the Phone .. FAILED error ... [Archive]

Aamir_Zia

10-22-2004, 00:10

X66 kept restarting as Power On the Phone ........
showing Failed error
& restarting :)

someone says me to Read eeprom from OK phone & write to Faulty Phone ...
but this X66 phone not goes to TEST MODE
just kept restarting when trying to enter in TEST Mode

The Solution I know that i have to Flash the Phone ......
but as the phone is not Going to Test mode ... how can i Flash it ??????

I have this Phone from 2 weeks but I can't find any 100% Soft ......
X60 by terror also gives error 10 ......

WHAT to DO

Can anyone know how to repair This Prob ...

Thanks in Advance ..

Aamir Zia

love&q

10-22-2004, 09:36

Yes!i also have problem for two weeks

jala

11-15-2004, 20:36

Use pana-extreme, flash then TFS options, works 100%.

opo

11-17-2004, 17:09

Try unlocking with vilany progy cracked by spunlock... it worked for me...

TONYTONY

11-17-2004, 17:34

PANA -EXTERME USERS.

I had X66 with same problem, flashed phone and TFS options and all worked fine but for a week only.

What is TFS? and any ideas why it stopped again??

tonytony

pali

11-17-2004, 22:46

i have here x60 with this problem FAILED msg .
unlocking using Vilany not work.
Is it hw problem or sw .
where to get any flasher with flash for X60.

Pali

TONYTONY

11-17-2004, 23:37

Free software for Panasonic is very hard to find!!

Most probably its software problem since my X66 is still working perfectly up to this minute!!

will test a few more days and post result..

11-18-2004, 16:21

TFS = FFS or FLEX or MAPPING (internal phone file system with pictures, logos, phone settings).
Also, current phone settings stored in X6X in FFS area.
After flashing FFS phone settings will be resetted and phone return to it's factory state (of course if ORIGINAL CLEAR FFS area was flashed).

TONYTONY

11-18-2004, 16:38

thanks TE for the info but with Pana-Extreme after you flash TFS all pictures and ringotones are still there... Could it be that it's not taking software properly?

tonytony

11-18-2004, 19:54

I think it's good idea to ask your software supplier about this. I am not PanaExtreme user/dealer, so I can give you no info about how this soft works. I use other software ("Alyssa") for this type of phones.
You can make small test: modify any WAP profile in your phone and then flash TFS. If you will see that after flashing your original WAP settings come back this means that TFS was changed after flashing. But really it is better to ask your dealer about all technical details.

B.R.
Mr. Te

kin88

12-02-2004, 19:39

yes , i try many program , pana-extrem write TFS and , terror , gsmkey , the phone can't go to test mode so i cannot write eeprom ,cannot fix my two dead phone , same error is turn on phone fail i try i try many pay program , no one can fix
any master can teach me thanks

pali

12-05-2004, 00:50

well , so there is no solution for fixing this phone ?
It must be Sw fault , customer get this after using WAP ...
i dont have Pana-extreme.. :(

Pali

shaaker

12-05-2004, 01:29

UFO box also work fine ;)

dominik

12-07-2004, 15:26

I flashed 3 X60 phones with Panaextreme with the restarting problem and the problem is still the same.Any advice.
WBR

TONYTONY

12-07-2004, 15:33

Flash them more than once with Pana-Extreme and always flash TFS before flash file. They should work frin after that!

tonytony

dominik

12-07-2004, 18:15

Flashed already 4 times same phone and its same, I have 3 phones with same problem,is there any any solution to reset the phone without card.
WBR

ryumahon

12-07-2004, 19:09

i think pana xtreme cant fix this problem.. i tried it also for many times using differnt languages and flashing tfs but still the same problem......... wat can fix this problem??? pls help us!! tnx!

mohibr

12-07-2004, 21:17

Hi,

Iv got the Panasonic X60/X66 Flash Tool 3.2, i havent really tried this software out yet, as i havent got any X60's in, does anyone know about this software? I also have the A34 and A38 firmware, if anybosy needs it PM me.

Best regards.

pali

12-08-2004, 01:17

how can u flash phone with this error ?
i cant enter flash mode , can any1 send me flasher and flash file ?

Pali

Ron2pet

12-08-2004, 09:52

thanks TE for the info but with Pana-Extreme after you flash TFS all pictures and ringotones are still there... Could it be that it's not taking software properly?

tonytony

Same problem! Also use Pana-Extreme

After tfs flashing,ringtones wallpapers stiil there,

I try also full flashing by chinese lang pack

But phone Stiil" Application Failed"

Any Solution

12-09-2004, 00:29

Flash them more than once with Pana-Extreme and always flash TFS before flash file. They should work frin after that!

tonytony

If you flash phone one time... two times... three times... twenty-three times... the finally content of FLASH chip will be the same like after first flashing.
And after forty-three times flashing: first think, then write.

Platijet

12-09-2004, 14:18

forget about software solution i have allready put good flash from another phone.problem is on tranceiver circuit of pcb(bielive it or not).
this info about the "data writen failed etc.." is internal error when phone searching for network.

so don't waist your time trying to find soft solution.
i allready work for this problem and if i'll find solution i will post it

TONYTONY

12-09-2004, 14:37

te,

I know what you mean but if SOULTION Works don't say THINK AND WRITE(cause I don't have any time to waste in writeing stupid posts).

If you write software more than once, mosta X66 phones work even though it does not make sense to either of us.

If you think you can explain why samsung phones which freeze interittently , work fine after changing their microphone, then explain this as well!!

tonytony

TONYTONY

12-14-2004, 14:18

ATT. PLATIJET

X66 When trying to power on, lcd goes grey for a few seconds and off again. Flashed it but still the same.

Do you have any ideas?

tonytony

Platijet

12-14-2004, 16:29

i have also same problem in many phones.until now i can't fix them.

pandekiko

12-14-2004, 18:08

I was repaired one x66 with the same problem with phone tools and good eeprom from working phone
no need to enter in test mode, plug the charger on x66 keep presing power button
all the time and try to make connection then upload working eeprom and after that flash with desired flash.

sorinm

12-14-2004, 19:08

pandekiko
how do you write eeprom with phonetool?

pandekiko

12-14-2004, 20:17

on the quick bar select eeprom editor, then go to
/file
/ open (merge) load eeprom text file, select good eeprom, then you must wait till the loading finish. Next go to
/file
/download to phone, you will receve mesage:

This will overwrite all parameters on the phone!
Proceed?

Press OK and that is

Aamir_Zia

12-14-2004, 20:34

hey man

i have the very same Phone
But Phone not entring to TESTMODE
Its JUST Restarting every 2 second

& Please attach the Good Eeprom File here ..

Thx

ryumahon

12-15-2004, 10:32

Aamir_Zia

12-15-2004, 10:40

phone not going to test mode

:mad:

pandekiko

12-15-2004, 16:10

I was flashed the phone with all flashes in the UFO tool support page, but the problem was remains, then I flashed the phone with Panasonic_X60_A54_Italy.X6x and the phone stop resetting, only light, then I used Phone Tool 9.5 for uploading EEPROM

TONYTONY

12-15-2004, 17:21

thanks pandekkiko but where can I find Phone toold please!

Thanks

tonytony

Elian

12-15-2004, 21:27

Download this soft to www.unlockeasy.com in PANASONIC DOWNLOAD SECTION.

:-)

bcnboy

12-15-2004, 21:45

Well I got a X60 whose display is totaly black as the phone on, nothing is display only back light working in it, I have flashed it with different versions using ufotools but nothing,read eeprom with the help of phone tool from working phone and wrote to the bad phone but still nothing, so today I flashed it again with the italy version and then uploaded the eeprom given above but still same problem, has any body repaired any thing like this. Please give suggestions.

regards

bcnboy

Uvedovle

01-20-2005, 17:15

Panaextreme should have built in software to do this.

I don´t understand

Uvedovle

01-20-2005, 17:22