View Full Version : SOLUTION: LG C1100, C1200 booting and then ''Phone not found"
- FOR THE 7050 CABLE: One 10k resistor has to be added from Vcc to pin 6 of phone and Vcc switch put on ON.
- For people in hurry: KEEP POWER ON key PRESSED during the whole Process, and it will work too...
regards,
gobi
P.S. Connections and pinouts are atached. ;)
mohammadmouazen
11-14-2004, 19:17
hi
thanks for info
br
Thanks a lot, man!
WBR Kasner
Many thanks, I just have one c1100 can happen this problem and also want post this pronlem, now you info is my need.
great work gobi
thanks for support
MGT SOFTWARE
11-22-2004, 17:06
did any body tested ABB cable for LG , I have ABB but there is no communication with Com port
CPUKILLER
12-27-2004, 21:00
great work man i really needed this big thanks to gobi
Does this problem apply to everyone? If so, is it possible to buy a "fixed" cable?
Does this problem apply to everyone? If so, is it possible to buy a "fixed" cable?
Only on same cables did the chinese cable factory forget to put the resistor.
Also when adding the LG C2200, LG L3100 one more soldering needed: pin 19 in phone connector hat to be connected to GND. (NO NEW CABLE, NO NEW ADAPTOR NEEDED, just one solder point)
Any 9 year old hobby electronist can make the 2 soldering operation in the cable. It take about 5-10 minutes only.
Come on friend, it is nothing difficult....
regards,
Gobi