mitsubishi "phone not found"

[edrovski]

Hi,
I have some problems with Mitsubishi m21i, software can not communicate with the phone, it replies "phone not found". Any suggestions for the problem?
BR
edrovski

[Gobi]

- The Vygis software is using FLASH cable both for unlock and flash the phone.

- Also the phone has to be OFF when connecting and working

- VCC Switch must be ON !!!!!!!!!!!!!!!!!!

- check your cable also according to the atached file

regards,
gobi

[qwerthj]

Hi!

Also i have problem with M21i unlocking. Always i get error "Phone not respond".
I checked my cable, by the picture, and all is good. I tryed on com port, and with Vygis USB->RS232 converter. Tried under win98, winXP sp1 and sp2.:confused:

WBR

[edrovski]

while the phone have connection strips from only one side, the connector has stripes on both sides, you have to check which is correct upside-down position, when you find which upside-down position is corrrect, make the cable as is shown on this picture.
BR
edrovski

[gsmuy]

so did u solve your problem? cause i´m having the same error that u had.
thanks
GSMuy

[gsmuy]

in one position, phone seems to be charging. in other position , phone does nothing.
which one is the right position, cause none of these works!

please help!
thanks
GSMuy

[vygism]

Hi.Mr.edrovsky is right-all these new Mitsubishi have little different connector and all China connectors really are not suitable for them,anyway it is possible to use and them :) You must make cable according schematic,which here
placed Gobi and later with pincers press cable connector.Main idea is,that if you look forwards to connector-needed is lower contacts side,not upper.If you press connector with pincers,lower contacts side goes little up and sometimes it is enough to have good contact.
Also when you put cable to phone(phone must be OFF)-phone must not show charging,if it shows charging-put off-put on baterry and try to put cable to phone again.

Regards,Vygis