Nobody Can Help?????

[jamohaki]

HI ALL,
i asked before for some help about sagem 920/922 that when u switch on it display"SAGEM" then switch off is it hardwasre proble or software problem how do i go about repair this problem i've got lots of these phones with this problem.hoping somebody will help.

[blaiseid]

Read old post or contact me.

Salam

[ludiana]

I think it should be hard way problem, But if it just develped this fault without falling, then try to reprogramme it , back.

[bentys2000]

1.rehot pcb
2.reprogram eep chip and correct it with sagem service2.5

[jamohaki]

First thank for ur reply but can u or anybody help me on how to reprogram the phone please be kind enough to tell me step by step how to do this.thanks in advance



ma mail jmkmk03@yahoo.co.uk

[phm_pete]

what kind of cable do you need for this phone?

[bentys2000]

kindly use sagem 9xx port com cable
best regards

[jamohaki]

i still dont know how to repair this problem or to reprogam eeprom, i dont know wich software to use,where to download it and how to use it.any one who can help?????

[bentys2000]

use a programmer 24cxx and pony prog or seeprog

[jamohaki]

thanks for the reply but can you tell me where to download this softs plus how to use them.

[farfour]

try this link to download ponyprog!!:

www.aec-electronics.co.nz

[farfour]

or butter this link:


http://www.lancos.com/prog.html


and there is a soft to repair after programming eeprom

good luck ;)

[jamohaki]

thanks frends for ur help