View Full Version : CV65 eeprom erased problem
Hi to all!
I tried to unlock this phone. I backed up the eepromFull with siemens eeprom tools. When I tried to upload the unlocking blocks by mistake I pushed the wrong button And it erased the eeprom. I have the full bakup but I can`t conect the phone with any software. Anybody have any solution for this?
THX in advance
hello there did you patch the boot care ????hav these blocks in your back up 0076,5008,5009,5077 ??? if so load them back to your phone
I did not patch the bootcore. I have the whole eeprom backup but I can`t conect the phone with any program to write eeprom back. Any solution?
Thx
Aamir_Zia
12-21-2004, 23:28
may be only Test Point will solve the Prob
or check the Battery .
where is the testpoint on the CV65?
blaiseid
12-25-2004, 10:09
Hi to all!
I tried to unlock this phone. I backed up the eepromFull with siemens eeprom tools. When I tried to upload the unlocking blocks by mistake I pushed the wrong button And it erased the eeprom. I have the full bakup but I can`t conect the phone with any software. Anybody have any solution for this?
THX in advance
I would want to know which programme you using.Email me , i can send you the best.
Salam
andihelldriver
12-25-2004, 11:11
here i wrote an answer, which could solve your problem
http://forum.gsmhosting.com/vbb/showthread.php?p=963404&posted=1#post963404
brgds
andi
Hi!
I erased the eeprom with eeprom tool. Now the phone can`t enter service mode. I tried with eeprom tool again, with SST cracked, V_klay, even tried the solution that andihelldriver explained, but it doesn`t work, too. I can`t calculate the boot password because the eeprom area is emty, and the bootcore isn`t patched. I have the full backup of the phone eeprom made with eeprom tool. I just need to write it back somehow :(
THX for the replyes
andihelldriver
12-25-2004, 22:35
no chance to connect with the newest version of the x65flasher?
version 1051 or 1054?
you can download version 1051 here:
http://www.dirk-hilmer.de/cx65/fileadmin/software/x65flasher.rar
as far as i know: the eeprom tool doesnt change the bootcore, so you should be able to connect at least in service mode with some tools, no matter if the bootcore is patched or not
most of the programs protect the bootcore, even x65flasher (except you start it in a special mode).
if you are not able to connect with the version of x65flasher mentioned above then i have no idea.
good luck guy!
brgds
andi
I have problem with cv 65,wont start up.I cheked flash,I try upload software with martech II but I got error masage.