View Full Version : usb service cable from original usb cable
can anyone tell me if you can convert the original usb data cable to a usb sevice cable for the e616v. if its possible, can you tell me how it done or direct me to a site that explains,
cheers
see attach for schematic
Bye
see attach for schematic
Bye
thanks for the picture but what is it saying. disconnect the + wire and connect it to the other three terminals or is it saying transfer the other 3 cables, tx rx + to the opposite side, same figure?
Anybody with a digital camera that can post a picture of his/her cable modified?
Regards
Raptor
Anybody with a digital camera that can post a picture of his/her cable modified?
Regards
Raptor
why ? take your cable to bits look closely for numbers so you know the pin out then solder a couple of wires like diagram above
why ? take your cable to bits look closely for numbers so you know the pin out then solder a couple of wires like diagram above
WHAT? im not into microscopic soldering, all im asking is what is the correct procedure to rewire the original usb cable to the factory service cable. dont worry i not interested in making money or ripping people off as some would say. i just want to unlock my own phone for my self.
cheers
see attach for schematic
Bye this would make more sense in brail?
alwaysberich
03-14-2006, 18:03
thank you for all who can help me with data cable :) :) ;)
thanks for the picture but what is it saying. disconnect the + wire and connect it to the other three terminals or is it saying transfer the other 3 cables, tx rx + to the opposite side, same figure?
It's simple. Connect pin 4 + 5 together.. After this connect also other 3 pins like scheme.