PDA

View Full Version : 6610 problem when simcard inside


ziko
12-27-2004, 20:11
Phone was dead and I reflash and can be switch on well.
But when insert sim phone switch and after 2-3 seconds switch off.
Any sugestion ?

Ziko

CPUKILLER
12-27-2004, 21:10
i hope u diid the full factory ui settings or u make full erase than flash it again and write good clean pm file and init locks do factory reset all will be fine if problem still persists than check for water logging around UEM chip and flash ic try reballing both atleast the uem most common fault=1-software-----2-uem faulty thats it

ziko
12-27-2004, 21:26
UI Defaults Ok, Time: 00:03
IMEI: 350894-10-301741-6, ASIC: 2
SimLocks Initialized, 00, Time: 00:01
and phone is OK !!!

Thanks for info... I don't use very offen UI Defaults :)


Ziko