View Full Version : unlock new samsung 3g
any solutoin for new samsung new generation (3g)
like z105
GSM SHADOW
01-08-2005, 17:45
no solution until know :(:(
dr_nokia
01-09-2005, 18:50
Here is details this did work with me:
1º Connect Pin 2 with Pin3 of Female DB9 Connector( you will connect in COM/Serial PORT) in one wire (you can buy Female 9 Pin serial in any computer shop)
2º Normally cames a USB DATA CABLE with this Phone (REF:PCB157ULE)
So you connect the GREEN wire of this cable with the wire who cames from the pin 2 and 3 of the female connector
3º you should have software Winimei Version 1.16(Qualcomm write System)
4º Turn on Phone without SIM CARD
5º Be sure you see on screen a symbol of screen (means you have modem on)
6º Check Modem port, use the one you says ON USE
7º In Winimei press Unlock
And Good Luck
This did work with me and the phone is already working
my problem was PHONE FREEZE but this program resolves all the problems
dr_nokia
01-09-2005, 18:52
Z105 Phone Freeze Remove... by sKaZi
as so other locks
There's in many forums the right solution to resolve the problem,so i want to congratulate all
the ppl that were involved on this.. since the cable pinout to the software procedure,because it
wasn't me that discovered the unlocking procedure. But, even that the information contained in
forum is right, it misses some important steps (important to those, like me, don't understant a
lot of phones unlocking). So, i'll try to demonstrate step by step the way i used to remove
the phone freeze lock... Z105 is a phone to good to don't be used.
So, what do have to get..
- PCB157ULE USB Data Cable (the one that normally comes within the phone box)
- If you don't have the cable, make it (http://webuser0.s23.deinprovider.de...e/z105cable.zip) thks Angelo
- An DB9 female connector (the on that connects to COM ports. you can bought it in any computer store)
- Qualcomm IMEi Write System for Z105 v 1.16 (http://webuser0.s23.deinprovider.de/Software/z105.rar) thks Angelo
- Z105 CDMA Modem USB Driver (Normally comes within the CD,or is in the z105.rar file too)
- Patience
The procedure is:
- Cut the PCB157ULE cable on half
- Inside you see 4 wires, Black, Red, Green and White
- Unite again the Black, Red and White wires... and put some glue tape on them
- Unite the green wires but leave it like that, whitout cover them
- Pick up the DB9 female connector and destroy the protection to reach the wires inside
- If you pick the front layer of the connector you'll see something like these
* *
5 4 3 2 1
-------------
\ * * * * * /
\ * * * * /
---------
9 8 7 6
- Pick up the wires of the 2nd and 3rd pine and unite them, making one wire..
- This wire i'll connect to the green wire of the USB Cable, but not yet..
- Install the drivers..
- Plug the USB female to the PC, the DB9 female to a COM port and the S100 conector to the phone
- (It should show an icon on the Inside Screen of the Z105 indicating that the modem is on, but
don't worry if it disapear.. If you don't see the icon or don't ear a sound from the phone, check the cable's
wires conections)
- Run the Qualcomm Software
- In the setup window, press ok
- In the main program do this (it worked for me, but you gotta be fast)
- Click Unlock and then put the wire that cames from the DB9 in contact with the green wire of the USB Cable, without unlinking the green wire
- When the program says "Serial COM OK" (or something like that), remove the wire from contact whit the USB Cable
- The program should pass to the USB ports verification and run sucessfully until unlock the phone.
The explanation for this is that, When the wire that cames from DB9 is in touch whit the USB green cable, the usb conection goes down,
so, it should be in contact with the green wire just when the software check the COM conection.. and that it's.
I saw some ppl with USB Ports Open Errors in the forums.. i think is caused by that...
This procedure is simple... you just have to do it right
If you have any doubt contact me, may be i can help you
hope i did no mistake posting some links but i think the solution is what rules isn´t it ? if any links are not acording to board rules so mods change the post and prepare soft to dl.
cu dr_nokia
will test this,think U man!
work with Z107V? ................
codec_romania
01-21-2005, 08:37
yes works with z107 v tested by me
mihai@codectelecom.com
for me no luck i tried make cable [green wire first connect to db9 and after comport good i remove to usb normal]and run on winXp have usb detect FAIL....
BR
Own
@all
please any one write schematic pinout and how to modify green wire[tx usb ] i tried many time but all detect usb time out
BR
Own :confused:
hi
pinout z105 cable
;)
br
Solution works wit Z105 ... 100% tested
yes work with Z105 but Z107V not work i tried many way or work if have win imei Z107v direct [V 1.21]
br
Own
you can read NCK Code with this and put it with other sim
i test it
unlockgod
02-07-2005, 22:35
i will try orange uk 107 tommorow :)
hi
pinout z105 cable
;)
br
m8, this pinout is for usb only cable but i've seen on this forum that we must use USB+Comm cable. I am confused now. what is the right pinout to unlock Samsung z107?
Have u tried to unlock z107 with only USB cable?
Thanks in advance
100% working!! tested!! :-)
Number-One
02-11-2005, 02:31
start unlock the phone...
check serial communication with the phone. wait...
serial com. good
wait. detect usb port...
sucess: detect usbport...
searching samsung modem...
usb port open fail
what´s wrong here?
tks
check your comport...
soft serch phone and don't fond it
Create Connect Pin 2 with Pin3 of Female DB9 Connector!!!
If there is not then not he is going to.
i test it on z105, it works but usually eroor with z107. i have winimei v1.16. Are there any new version?
Number-One
02-15-2005, 21:38
check your comport...
soft serch phone and don't fond it
but modem is in usb port right?
any 1 want modified cable
contact with pm
MickeyKnox
03-12-2005, 12:32
Follow this guide!
It worked 100% for my Z105 :D
i already unlocked one now, thaks m8 for your guide :)
unlocksolutions
03-22-2005, 11:10
buy the z105/107 clip its working perfect in 3 sec unlock your phone.
regards
sander
buy the z105/107 clip its working perfect in 3 sec unlock your phone.
regards
sander
he he
price for clip?
regards
no reclaaaaaaaam here go out for this
solution is alreday freeeeeeeeeeeeeeee
i just unlock one Z107 but after cannot dail anything. i check in phone menu network option "GSM" and same. Phone is unlocked and find network but cannot dail. I check barrings and all other. Can some one give me some advice?
ringtons
04-01-2005, 10:10
m8, this pinout is for usb only cable but i've seen on this forum that we must use USB+Comm cable. I am confused now. what is the right pinout to unlock Samsung z107?
Have u tried to unlock z107 with only USB cable?
Thanks in advance
no need to damage usb cable that comes with phone connecting pin 2&3 on com port is all you need and run soft works 100% i have unlocked dozens of 105 and 107