6600 dead phone plz help

[ftl's recovery]

i flash a dead 6600 using tornado flasher and cheking the box of BT, MCU, and PPM.
MCU and BT flashing complete but it could not erase some area in PPM. i recieved failed in erasing and repowering the mobile.

i tried flashing only MCU and BT. i recieve flashing complete and done. repowering mobile ok. although the phone does'nt turn on.

then i tried flashing PPM and BT. erasing was complete but there is an error in writing process. i recieve failed in repowering the mobile.

but after flashing only PPM . the flashing was complete and done. repowering the mobile is ok. although the phone does'nt turn on. here i switch on the phone. the lights did shine just in seconds but the phone was not alive

your solution, ideas will be highly appreciated

[JulesJ]

Refow board using controlled heat and then attempt to flash again.remember to upload PM file.

BR

[tigertrn]

I alive one 6600. I use griffin and I flash only the MCU and PPM (hiest version which I have) and the phone powered up. My be this phone dead only software, so your phone my be have hardware problem. If have u must first done the hardware problem and then flash MCU and PPM, and phone must be alive. I alive one 3100 in this way - furst repair the hardware problem, and then I flash phone with MCU and PPM. So Good Luck.

[ftl's recovery]

tnx to all of you. i will try it