View Full Version : power button not responding v200
oladele08
02-18-2005, 20:49
pls, somebody should help me i have v200 the power button is not responding
when swiching it on. what can i do ? :eek:
cellularry
02-19-2005, 00:00
pls, somebody should help me i have v200 the power button is not responding
when swiching it on. what can i do ? :eek:
Resolder U100. problem will be solved 100 %
i hope this solution will work ........
PHONESTREET LIMITED
02-24-2005, 14:03
who have asvice manual 4 v200 samsung
help
and kindily show me where U100 ca be found in the circiut
thanks
oladele08
02-24-2005, 21:14
it can be found onn the uper side of the sim reder dat black flat icy
oladele trey heating the black ic just above the the simcard reader opposite it there is the system battery try heating using rework station and flux
PHONESTREET LIMITED
03-09-2005, 23:08
now when its on difficult to swich off when its off dificult to swich on
cellularry
03-10-2005, 09:33
now when its on difficult to swich off when its off dificult to swich on
Resolder U100 and your problem is solved 10000000000000000000000%.
I have been saying this for long. And i repaired hundreds of V200 with the same problem and all are working perfectly
multiroamy
03-10-2005, 20:28
good job CELLULARY and others ,i have v200 power button not responding and ear piece not working , is there a link between the problems .
cellularry
03-11-2005, 09:42
good job CELLULARY and others ,i have v200 power button not responding and ear piece not working , is there a link between the problems .
No there is no link between the two problem, first check your earpeice and second your flat cable.
m_chakroun
05-22-2006, 10:46
I already resolered U100 in my V200 but nothing, phone charge but doesn't power on I also checked keypad, any idea please ? :confused:
I already resolered U100 in my V200 but nothing, phone charge but doesn't power on I also checked keypad, any idea please ? :confused:
use flux on the ic and aply a little pressure when heating
makhan107
05-22-2006, 21:17
X600 no signal anybody can proviod its solution?I would b thankful
it has very easy soution///
just check that ur power button inner point will not show impedence with ground that mean its link is break..
just jumper a wire from this to u100 pin one (from left to right) from top left corner ...
if any one have difficulty post here i will post a pic here
best regards
br khalid:eek: :rolleyes:
mobile world
07-12-2006, 09:29
Kindly post me the pictire , then please if there is a solution for the kepad light also, here is my address. objz2@yahoo.ca
resolder u100 ,pin 1 for power on .100/100
cruci davids
07-14-2006, 12:49
:confused: please could you send me the picture to the solution of samsung v200 power botton. thats the connecting of a wire to the pin one of u100 to positive pole of botton.
this is my address jredion4play@yahoo.com