sharp GX 10 (d) freeze

[samanthe]

dear friends,
when I switch on the phone it freeze ....desplay stuck,I was flash the phone but still same,and I was remove the internal batt: and fixed but same,
please give me the solution,
regards,
sam

[sergius]

dear friends,
when I switch on the phone it freeze ....desplay stuck,I was flash the phone but still same,and I was remove the internal batt: and fixed but same,
please give me the solution,
regards,
sam

hi dear
Remove SIM

1 Press 0, 3, top right key and Red key together for about 3 secs until a white display is shown.

2 Press 0, 1, 2, 3, top right key, 1, in sequence. The Diagnosis menu should be displayed.

3 Enter 99 and press the top right key. A message should be displayed saying Input Mode No:


4 Enter 1 and press the top right key. The following messages should appear:
· EE_FORMAT START
· EE_FORMAT OK
· EE_INIT(1) START
· EE_INIT(1) OK
· BBSRAM CLEAR END
· FINISHED
· PLEASE ANY KEY
5 Wait until all the above messages are displayed and then press the top right key.
6 Press the M key (very important). Message should display Diag Param Saving.
7 Press the red key to power down the phone

BR

[donaladino]

this is eeprom fault u must reset eeprom .
1, push at once key 0+3+right option key up+red key (white screen)
2, in sequence push key 0,1,2,3, right option key up,1 (service menu)
3, write 99 and push right option key up
4, write 01 and push right option key up (now start RESET EEPROM)
Wait.....
5, push any key
6, push blue key menu (save)
7, power off :)

[samanthe]

thank you very much it is work now very well,thank you again,
regards,
sam

[kiriazy]

you are doing a great job ..

keep on & thanks alot for your help

[joc]

Thanks!
It was very helpfull!

regards

joc