EEPROM - on board programming

[stanley]

hello,
I have dead T10 (in forum Topic: T10 - wrong generation of EEPROM !!! ), and now I need rewrite EEPROM (by cable is not possible at this moment) via EEPROM programmer.
Please , how software (for I2C communication)I need for write (read) EEPROM (24256) and what is connection of hardware (LPT direct ?) - programing interface (for on board programing - withou desolder EEPROM) ?

many thanks for Your help
Stano

[FireBird]

Use PonyProg with serial interface. I think it is not possible to reprogram that EEPROM in T10 without desoldering at least the four data pins. To desolder the chip use some thin metal plate, put it under the EEPROM and use reasonable force while desoldering.

Best regards,
FireBird.