Odia The Ultimate
07-28-2005, 16:13
1. Remove the cover from your UFS platform box.
2. Align the 16 pins and push into place. The 10 copper contacts MUST face towards the front of the PCB, NOT the back.
3. Replace the cover and enjoy.
See picture below for correct installation within UFS3 Excalibur
http://www.sarasbox.com/IMGS/Hwk.jpg
Regards,
Odia.
2. Align the 16 pins and push into place. The 10 copper contacts MUST face towards the front of the PCB, NOT the back.
3. Replace the cover and enjoy.
See picture below for correct installation within UFS3 Excalibur
http://www.sarasbox.com/IMGS/Hwk.jpg
Regards,
Odia.