View Full Version : problem with E616 when i tried to flash it
tayeb_am
08-13-2005, 23:39
Hello all
i got this problem when i tried to flash my E616
note: i am using modified USB cable (5+4 shorted, 8-9-10 shorted)
but the phone still need the battery to detcts by PC
i tried this in 3 PCs
thanx
CONTACT-GSM
08-14-2005, 10:53
try with normal cable without modified
Hello all
i got this problem when i tried to flash my E616
note: i am using modified USB cable (5+4 shorted, 8-9-10 shorted)
but the phone still need the battery to detcts by PC
i tried this in 3 PCs
thanx
there seem to be no error here yet... seem working normally, you probably need to be patient a little bit more.
bR
tayeb_am
08-14-2005, 14:19
thanx all
i waited for 30 m but the same problem
Hello all
i got this problem when i tried to flash my E616
note: i am using modified USB cable (5+4 shorted, 8-9-10 shorted)
but the phone still need the battery to detcts by PC
i tried this in 3 PCs
thanx
If the phone still needs battery to be detected by pc it means your modified cable is not modified properly
tayeb_am
08-15-2005, 22:09
i got it with my redbox2 man
vishalmadhvani
08-17-2005, 18:36
Hi
That software takes like 45 mins to complete its job.
You need to wait. I have used it for my NEC E313 but it doesn't work now.
Make sure its the right flash file.
When you plug the phone to the pc does the phone turn on it self and load up to the bootloader. Not sure about the NEC E616 but the screen should turn yellow and then a few seconds later blue. It will only turn blue if the drivers have been installed.
Looking at the screenshot, it looks like the software has detected you phone and is working. Leave you computer idle while its working and make sure you have turned off your screensaver. And you also have to make sure you PC does not go into standby.
Good luck with the flashing.