View Full Version : s65 Bootcore patch
kotsiarosstavro
08-19-2005, 14:34
Hi mates !
I have a S65 and I have runned px65v3. S65 did a beep and went off which means that the patch runned succesfuly I suppose... The problem is that when I try to patch the phone with V_Klay 3.3 nothing happens. When it asks to press the red button, I press it but V_Klay doesn't recognize it...
im not sure, but if you started px65 it should write OK, or something like that on your screen.
Greetings
kotsiarosstavro
08-19-2005, 16:19
When I try to run px65 again it writes : " Bootcore already patched ". I have tried to patch one CX65 with V_Klay but the same problem ! I use DCA-510 but it is resoldered in some parts of its circuit because of some problems in the past... But it works fine with Software update or Papua Utilities or every other software which needs pressing the red button. Is it possible that the cable works fine with these progs but not with V_Klay ? I don't have another cable to test it...
HI!
Which version of V_klay you have ?? Mayby thats a problem. Anyway, if i were you I would download driver that emulate COM port form USB and try then.
But i may be wrong.
Greetings
kotsiarosstavro
08-19-2005, 17:10
V_Klay 3.3. I have installed the cable's drivers which attribute a virtual com port to the original USB port...
hmm, thats wird.... I dont have a problem, cause i have COM DCA-500 and it dont make any problems.