SPV code error..................

[Yashaka]

HI,

Here is a problem with my SPV "its bootloader is v0.98.........................i calculated code for that but when i apply this code it gives code error ................... if anyone have any solution for that so plz help me for that ...................... thx

posted bellow the pic of code caculated............................

[Yashaka]

anyone solve this problem....................

[AWAIS]

just hard reset your spv



STEPS FOR FORMATING SPV.............................

Check that there is no SD or MMC card in your SPV,
or that the protective plastic has been removed
Switch off your SPV
Remove the battery, then replace
Start up your SPV by holding down the voice memo record button
After the ""Card Found"" message, an invitation appears,
press on the joystick until the ""Canary"" menu is displayed (1-2 seconds)
Confirm choice number 8: ""Erase IPSM""
You know the procedure is successful
when you see the word ""PASSED"" appear at the bottom of the screen.
Confirm by pressing on the joystick, you will then find
yourself back at the menu.
Remove the battery, wait for a few moments, then replace.
Start up your SPV as normal.
It will then go through the initialisation cycle..
which takes a few minutes... "