View Full Version : alcatel club DEAD
brittnee
07-08-2001, 17:11
i've heard that the way to repair dead alcatel is to flash it again with a working file, should this be of the same version?
but my problem is i can't read nor write the flash with andromenda!!
thanks
take good alcatel,connect it and read it with Andromeda.Then connect the dead one and flash it.
some time i succed :) some times not :D
good luck.
acyl2000
07-09-2001, 05:24
you must comfirm that your phone is sw or hw problem, if hw problem then you can't flash it with andromenda, after you change the I/C than your phone should be ok.
Power I/C: 02CJH8T/PTWL2207A. :D :D :D
Hi Brittnee,
Hi Brittnee,
Dead Alcatel BE1 can be revived by using Zulea's Service Software, such as v11.8, 12.3 or the special version for 16D's, eventhough they are primarily intended for unlocking...
Their are cases also of dead alcatel BE1 which is caused by wrong flashing...Mihnea's Repairer is very good for this..
But since your phone doesn't respond with Andromeda, (assuming you got good batteries)...I presumed you got a hardware problem..Check the two fusible resistors, sometimes colored blue at lower left portion of the board at board's battery terminal side, this usually get "open".
If it is intact.. I'll go with acyl2000 the IC PTWL2207A might be defective.....If you can't locate the said resistor mail me.
Regards,
neb
acyl2000
07-10-2001, 09:06
Agree that solution. :D ;) :D
PTWL ic is most likely the problem 99.99%
Does anyone know where i can buy them new?I need +/- 400pcs
eureka8888
07-29-2001, 12:31
i also have this problem, phone not detected by andromeda, <br />1) i connect a working phone, ot easy,read the phone(it's imei appears on screen)<br />2) remove the working phone and place the non working phone(alcatel club),<br />3) read flash, then appears "check bat"<br />is this hardware problem?<br />thanks
can any one tell me where PTWL ic is located.