How to disassemble T28 ?

[MiChel N]

Hi,

how can i disassemble my t28

Thanx in advance

MiChel,

[Hanukkah]

Hey dude!

Use a small flat screw driver and work from the bottom up to the same side. The t28s are interlocked using canals.. so you have to lift them up a little slowly. You can use specially made plastics srewdrivers for these if you don't want a little damage to the casing. And be wary of the mic connector that connects the flip to the board.

[Pandemonio100]

ATTENTION!!!! don't try to remove pcb board after you have removed the screws, you can damage the BGA components.
Use a hair dryer and it in the back part of the telephone (the metallic part) but not to overheat too much it, after remove the PCB.
GOOD LUCK ;)

[MiChel N]

hi,

well i did as you siad and it worked fine!1
i used a spacial tool form my siemens C35 work set.
and the casing looks just fine!
i had to remove the cover because there was some thing rong with the mic. connector but i fixed it.

i didn't have to remove the pcb because there was nothing rong with it but thanx any way.

so i want to thank you people for replying.


Greetings from holland,