PDA

View Full Version : sgh 600 dead.. what should i check first??

CellM@n
12-05-2001, 15:58
Any help??
Bert
12-06-2001, 04:25
Hello<br />You should try to flash it at first <img src="smile.gif" border="0">
CellM@n
12-07-2001, 06:59
i ll try it..

thx
.::AkhavanGSM::.
12-11-2002, 08:36
I have same problem.I can flash it.But when press pwer on switch just TOP LED goes on.
When I connect charger, (even when board is not attached to battery) LED goes on and nothing
Bert
12-11-2002, 09:51
That's mean your flash file incorrect , 600 has two hardware version, you have to change your flash file!
CellM@n
12-11-2002, 19:40
How to flash Sgh 600?
When i try using turbo downloader, always said
NACK Receive
times 0.0

Why ??

pls help

rgds
Svetli
12-11-2002, 21:46
hi guys.

but this problem is possible not only SW !

one friend have sgh-600, phone work normaly but the friend use glue on display to connect to PCB. after removing glue phone stop work and now have some problems like GSMLight.

i tink that problem is HW.

@CellM@n
what you make with your sgh-600 1st: flash it or repair HW problem ?

regards
Svetli
hhy007
12-11-2002, 22:58
%60 13 mhz crytal fail
xmobile
12-11-2002, 23:31
13MHZ damaged or sometimes damage eeprom IC
themobileking
12-12-2002, 17:31
try to remove the lcd and them power it up ...in more than 50% of cases it works...

Also check battery connector .."+" and "-"..check for shorting ...sometimes the charging connector gets short...and as a result the set gets dead.

The 3rd and most reliable things to do ...is check and change the fillowing

Eeprom
CPU (very important)
and 13Mhz crystal.

Rgds,

themobileking