View Full Version : ZV30 strange codes.
ZV30 sw ZV30BUEL2
Wait...Ok Time: 00:02s, 828ms
Read Settings
Master Control Lock 00000000
Nck :0r2640
Nsck :0r4640
Spck :0r6640
Cpck :0r8640
Done.
using usb cable.
regards
Sjakie
its not reading good
do direc unlock
thankx
falak
Hi, no option for direct unlock in programm.
regards
Sjakie
florin35
03-03-2006, 15:09
you have your answer yhere:
http://forum.gsmhosting.com/vbb/showthread.php?t=275956
you have your answer yhere:
http://forum.gsmhosting.com/vbb/showthread.php?t=275956
not really.
regards
Sjakie
not really.
regards
Sjakie
If Winimei cannot handle this phone too (as you said in another thread), almost sure there is some hardware damages on your phone. From your log, RX and TX lines are SHORTED together (because what you have here - readed back - is EXACTLY what is send to phone). This was my first thinking and because of that I say about COM adapter with 2-3 pins shorted. Check phone connector, maybe damaged, or maybe your cable have problem on this phone ('chinese quality cable' maybe not fit exactly into phone connector and make short RX/TX pins).
I just tested ZV30 and all is working well with USB cable.
ok, thanks for info.
That could be the case, too bad i cannot check it, had too give back phone yesterday.
But there will be others i get.
Was under the impression it was new protected soft, as new winimei v2.0
wont readt this phone simlock without id and pass and connection too Samsung service page.
And i saw other phones getting unlocked with this v2.0.
Also downgrading seemed too help on other z series to read out codes.
Ill wait on another ZV30 to try.
En believe me i use my brain.
regards
Sjakie