K600 wont take certloaders? Help!

[afghanjohnny]

I flashed a K600 with R2J005 yesterday and after stupidly pressing "repair/unlock" in sonicsbox before uploading customize.xml the phone now subbornly wont take certloaders. I can´t even "Read CID" anymore.

Recover in DVT 13.8 reports sucess on CID19 but nothing changes.
Recover in TMS just says that my battery is depleted which it isn´t.
Recover in Sonicsbox is an sucess for CID36 Red, but nothing changes.
Recover in SETool cracked reports the following:
----------------
GUI v0.91373/UNI
standalone version engaged.
Card serial:xxxxxxxxx
Loaded 49 flash descriptors
RECOVERY MODE STARTED
Open COM port OK
PHONE IS INVISIBLE (00000000)
Recovery:041213 1451 MATCXC1325413_CERTLOADER R3S
Fetching phone data from OTP
OTP status:0 locked:1 CID:36 PAF:0 IMEI:NUMBERSOMITTED CERT:RED
bad file, will not flash it.
Recovery failed. Phone dead.
Elapsed:11 secs.
-----------------

Which file is bad by the way, why will it not flash it?

Any ideas? I read that the K608i had a resistor that sometimes had to be shortcircuted, is it the same for K600?

Could a miniUSB cable be the trick?

[.::Unlocker.::]

convert to brown.
full flash.
unlock.
convert back to red.
customize fs.

[afghanjohnny]

@.:Unlocker:.

In which software do you reccomend this procedure?

I have tried DVT and SEtool. SEtool cracked complains of a missing file, TMS says the battery is low.

I am at my wits end... ;)