still philips savvy.

[timitiz]

Hi to all..
how can i make eprom dump of philips savvy
can anybody tell me step by step how to?
which soft i need , type of datacable?
do i have to desolder eprom?
Please tell me, i got a lot of them ..
Greetingz Timitiz

[talenat]

Hi,
I make this dump like this.
Open the phone and desolder pins 5,6,8 from
EEPROM 24C32.
On 5 and 6 connect
I2C interface for Ponyprog.
Then connect 5 volt supply on 8 (+) and minus on pin 4 (this is the common for I2C and supply ).
Start Pony and read your dump.
The first time is the most difficult but when you have lots of them you will catch practice.
Bye

[This message has been edited by talenat (edited 31 August 2000).]