View Full Version : v3 white screen! lcd and keypad flex 100%
hi
i got v3 white screen.
changed keypad flex and lcd , same problem.
i have flashed the phone , same problem.
i guess its hw prob on main board.
any directions where to look ? phone is not water damage.
thx
Kashif Khan
07-12-2006, 01:13
if you have smart clip so after repair PDS write OCR version .
BR
Kashif Khan
Dr-mehdi
07-12-2006, 02:27
tried and working
loook this link www.motox.us
Br Dr-Mehdi
if you have smart clip so after repair PDS write OCR version .
BR
Kashif Khan
i do have smart clip , can you explian ?
i tohught its hw prob cuz phone goes into flash mode also white screen.
after repair pds what is OCR version ?
guys , i have repairede PDS , full flash the phone , same problem , after cleaned board , no screen at all.
i think its hw problem , anyone can give me directions where to check lcd components ???
baraka42
07-13-2006, 11:40
@ have you check-resolder flax socket on pcb ?
wbr
@ have you check-resolder flax socket on pcb ?
wbr
yes i have
from searching it seem that small IC near socket is LCD ic ?
i removed it , it seem foulty , point are missing.
anyone got jumper for this solution ?
i have a pink v3 in my shop right now. changed lcd, keypad flex and speaker flex - still white. trying a flash right now, then going to try smart clips repair pds. i'll keep you updated.
use usb smart v3.9 and flash with a monster pack. tried it with a .shx extension monster pack after bad unlocking with crude soft from this forum.
regards
well it turns out that the new lcd i put in wasn't new - it had the same white screen problem. i found another lcd in the shop and the phone is now fixed.
mehdi_naghous
07-16-2006, 23:51
repair pds and flash it by smart-clip 100% work
mehdi_naghous@yahoo.com
+989131154402
I think the main White LCD problem is a missmatch on LCD and Flex try flashing phone or repalce the LCD...
wilson-yang
07-21-2006, 04:38
there a BGA component name Q960 beside-outside the MB connector,it has 10 pins,
--0 0 0 0--
--0 0--
--0 0 0 0--
you can shorted up left and right;down left and right without Q960.
thx
do you mean like that ?
wilson-yang
07-22-2006, 04:53
Q960 is a PN protect LCD from GND
- 1 2 3 4
- 5 6
- 7 8 9 10
:1shorted to 2;3shorted to 4
:7 shorted to 8;9 shorted to 10.
thank you !!
i will test it will post results.
o.k last thing ...
anto73 just post this
http://forum.gsmhosting.com/vbb/showthread.php?t=316982
and his solution only half of your .
i put all together , please tell me if i correct in what i made.
thx
just tested
solution works 100%
4 links
1-2
3-4
5-6
7-8
thx for the help
wilson-yang
07-28-2006, 04:06
haha,Trabel you are a smartman thank for you test!