View Full Version : Samsung Sgh 600 Cannot remove sp lock by Eprom Reset.
Dear Master
i have a samsung sgh 600 GSM phone is lock by SP Code, i Had try to reset by keyin *2767*3855# full eeprom reset it not accecpt, so i used *2767*2878# it show Custom E2P reset.Than, phone restart by itseft,try to insert sim card but sp lock still apear.
my phone version is FLD_2c6 g60sh270 i try to used the Dos unlocking software but still cannot open
PLSSSSSSSSS HELPPPPPPP.......
Thank
Henry
fast@tm.net.my
:rolleyes: :rolleyes:
ama_the_wizard
06-21-2001, 23:28
This code doesn't work with some versions , you have to re-flash it and use Samsung chbox600 software to unlock it ...
;)
GsmSolution
06-23-2001, 12:07
Originally posted by Henry:
<STRONG>Dear Master
i have a samsung sgh 600 GSM phone is lock by SP Code, i Had try to reset by keyin *2767*3855# full eeprom reset it not accecpt, so i used *2767*2878# it show Custom E2P reset.Than, phone restart by itseft,try to insert sim card but sp lock still apear.
my phone version is FLD_2c6 g60sh270 i try to used the Dos unlocking software but still cannot open
PLSSSSSSSSS HELPPPPPPP.......
Thank
Henry
fast@tm.net.my
:rolleyes: :rolleyes:</STRONG>
HI
Clone the eeprom. :D :eek:
hi! friend use SGH-600 Test Program Ver 3.17
but u need special cable(external power).
mail me I send it to you with instructions
Regards!
GsmSolution
06-23-2001, 21:01
Hi Markaba
Can you send to me with instruction.
Thanks. :)
hi!MARKABA,ME toooo need that soft preferebly with instructions.
my add;udai_electronics17@rediffmail.com
To all check your mail
Regards!
GsmSolution
06-29-2001, 09:14
Hi Markaba
Thank you for sending me this program.Can you send me special cable diagram. :)
Instructions!
U must put travel charger in your Data cable
Phone must be off
1/run the soft
2/choose Next country
3/choose France Telecom
4/choose M-LINE
5/"want to modify configuration"answer=No
6/In the Menu Production choose "Test"...u get this message:serial Communication Good with PC.If u don't get this message go to menu "reset Mob" before u go to "menu Test"
7/Go to menu Production;choose "write IMEI" u get this another message
Do you want to use Baracoder?answer=NO
8/Press F5 to read your phone:IMEI&setting
9/Press alt+U at the same Time to unlock your phone in few seconds
10/ That's all
NB:For SGH2100-SGH2400 u follow instructions 1...9:That's all
Sometimes u can get this message in the model SGH600 "call custumer service".To solve this problem U must go to the Menu Production and repair your phone with menus "B'D & BATT".."ADJUST RF.. "RADIATION"
For SGH2100-SGH2400 run SGH-2100 Test Program Ver3.18
For SGH600 run SGH-600 Test Program Ver 3.17
ET VOILA U UNDERSTAND...)I hope
Regards!
markaba@ifrance.com
markaba@netphonegsm.com
I use original cable from Gsmfactory.com(129000FF)