View Full Version : Philips SAVVY cable
Hi,
I can't find SAVVY cable schemantics, can anyone has it?
Or can someone please send me hints for eeprom solution?
I have TCD128/BB
Thnx a lot in advance.
~ChM
Oh
I've tried all software I have and none of them supports 128/BB. http://www.thoic.net/gsm/ubb/frown.gif
Which soft may I use?
~ChM
Hi,
I was realy lamah.
Now I hope it's better http://www.thoic.net/gsm/ubb/smile.gif
I urgently need to unlock Savvy 128/BB via cable. I can't get run Savvy Tools 1.5 Cracked by CyberPhreack.
It still tells:
"-" is not a valid integer value.
and then wants to enter registration.
Is there any other soft or is 128/BB unlockable only by eeprom solution?
pinout:
KEYBOARD AT THE BOTTOM
12|11| |10|9|8|7|6|5|4|3|2| |1|
1 GND
4 TX
5 RX
if oyu cannot get ca cable (like me) just do the following:
take a standard fbus cable (gnd rx tx) and solder crocodile connectors to the ends of the cable (instead of a connector). just put steel nadles in the system connector and connect them to the crocodiles.
beware: nadles mustn't connect each other. otherwise your phone will get damaged !
use savvy tools 1.5 cracked by cyberphreak to read NCK. then insert a wrong card and enter NCK. thats all.
software can be downloaded at http://www.easynet.hu/~phonesoft/
good luck !
works! all tested !
greets from Squesch
Thanx a lot for a guide.
I finaly did that beast. Cable wasn't problem, but savvy tools 1.5 cracked by cyberphreak didn't worked for me.
So I used Savvy 1.1 by Saras and read the phone. As I have 128/BB, I selected 128/BL and NCK works fine.
That's all.
P.S: I've tried All Philips Tool v1.01 too, it worked well, and it can read NCK code too.