View Full Version : Exx serie pinout
I hve problem to boot VLE phones. i'm sure that it's cable problem.
So can every one send a fonctional pinout but for otuf dongle.
THX.
Gsmsassa
10-15-2006, 14:10
I hve problem to boot VLE phones. i'm sure that it's cable problem.
So can every one send a fonctional pinout but for otuf dongle.
THX.
u can found pinout in support otuf
gsmmasters
10-16-2006, 08:30
I hve problem to boot VLE phones. i'm sure that it's cable problem.
So can every one send a fonctional pinout but for otuf dongle.
THX.
Here is direct link
http://www.gsmmasters.com/epinout.jpg
Do not use rts for ignition, connect just rx,tx and gnd
The problem is when i try to read codes or use a direct unlock method ,
I get the following messages:
Phone connected
Phone not responding
What' s the problem??????????????????????:confused:
Gsmsassa
10-18-2006, 12:50
have u tested in other phone ur cable modifie
all VLE models, but the cable works fine with others SOFT.
Gsmsassa
10-19-2006, 10:21
all VLE models, but the cable works fine with others SOFT.
check batterie if it is to place well in connector of battery
Only the Tx, Rx and GND should be connected. Some other SWs use RTS too. If RTS is connected, disconect it.
I recently got my box with all the cables
Want to confirm if the Exx cable can work with C552X model
I tried to connect for the first time yesterday but failed. tried fast and slow buttons but still "Phone not found"
Is there any need to modify the cable? If yes please advise how I can do this.
Regards
Chubby
Sometime cable don't touch to pads, so just try to push it a little (or take off the shield) and try (you'll be able to push it deeper).
Regads,
Alex
EXXX cable wont't work with C551/C552/C651/C652/ELLE phones.
These phones have pinout like ***/Th4 but the connector is thinner.