View Full Version : testpoint procedure using usb-smart...
Hi, after using lot's of "search" I still have a question: I'm still using only usb-smart and don't know what testpoin procedure looks like...
what to do in oreder:
-connect usb cable (phone or computer first)
-connect ground
-connect testpoint
-press "do selected job" while selected unlock sp
-disconnet testpoint
P2K says only when to disconnect it sometimes...
thank for Your answers in advance...
visualtech
11-24-2006, 20:31
1. connect test point
2. connect cable to phone and also computer
3. insert battery to phone
4. wait about 10 second for driver instalation.
5. when usb driver is installed,disconect testpoint and click on do selected job
Sorry man, but doesn't work...
V3r with latest P2k easy tool:
Connecting to phone ...
Switching to P2K mode ...
Connected to: 'Motorola Test Interface'
Switching to flash mode ...
Connected to: 'Motorola Flash'
Connected OK
Bootloader version: 0A30
ERROR: Please make TESTPOINT on phone for this model!
ok, I did it but I connected TP after pluging USB cable, maybe thats right procedure...
spinbaaz.com
12-01-2006, 19:48
what is the tested procedure??????????????????
as visualtech wrote before, I only switched point 1 and 2 so first I connected USB cable...
Moderate
12-02-2006, 21:24
Today I tested One v3x with usb smart.
I followed the following steps
First of all i connect the cable to the computer and to phone , pc starts installing modem drivers.after that i opened and made tp pc started installing Flash Interface drivers after that i select the Splock and make tp on 3g phones.and click on do selected jobs,usb smart asked me to disconnect the tp and i did and it sent the boot to the phone and within five seconds it unlocked my v3x.It was damn easy procedure.
Regards,
Moderate.