PDA

View Full Version : M65 after direct boot......is DEAD!!!!!!!


zeljko_c
12-23-2006, 10:20
After I try to enter dirrect boot in service mode, the phone was be booted to service mode (shows on displey). But wath`s happend? After entering in service mode become an error message: "USB Dongle Driver not instaled" and press OK! After closing the program, phone is DEAD!!! Afther that I try to run
again in service mode you can see on the picture!Also you can see the pictures what is happen when is started from normal boot pic. 02 and patched boot pic. 03!

This is some Joke or what?

I waitng for your answer.

Zeljko_c

japunlock
12-23-2006, 17:15
use testpoint something alike happened to me but phone turned off cause battery was low and you need to use repair with recover bootcore

SST-GSM
12-25-2006, 10:33
After I try to enter dirrect boot in service mode, the phone was be booted to service mode (shows on displey). But wath`s happend? After entering in service mode become an error message: "USB Dongle Driver not instaled" and press OK! After closing the program, phone is DEAD!!! Afther that I try to run
again in service mode you can see on the picture!Also you can see the pictures what is happen when is started from normal boot pic. 02 and patched boot pic. 03!

This is some Joke or what?

I waitng for your answer.

Zeljko_c

If sometimes the direct bbot procedure is not finish , for example due to too high speed , then try to repair the phone with repair button ,patched boot method and lower speed.
About the error "dongle driver not installed" please contact to our support email