need pinout for cect m1818

[mishiko_gsm]

hello
i need pinout for this china miracle MP3 CECT M1818 ,in support can't find

[InfinitySupport]

Hi,

Here is instruction:
http://forum.gsmhosting.com/vbb/showpost.php?p=2212036&postcount=7

[shahidm]

sir for this method i cant find pinouts from m1818
plz help us and tell us correct pinouts

[InfinityHelp]

hello!

how can we find pinout for phone which we dont have in hands?
please take multimeter and check where is GND and charging pins.
after this done- check all collected by us pinouts for china phones. maybe you will find smthng similar

[shahidm]

hello!

how can we find pinout for phone which we dont have in hands?
please take multimeter and check where is GND and charging pins.
after this done- check all collected by us pinouts for china phones. maybe you will find smthng similar
hello
sir iwill try again and again but could found pinouts for this model(m1818) plz i need pinouts its urgent

[InfinitySupport]

@shahidm
you must install and use latest "pinouts" to get info about M1818 pinout.

[nishaon]

My M1818 PDA set has 2x6 pinout, but the chenese miracle pinout(in latest pinout) has it with 2x7 pinout. So what should be the pinout for this set
M1818 (SUPPER LCD & PDA)?

Please help me as soon as posssible.

[HAROON's]

cect 1818
keyboard top, connector_1x12_mini
5: Gnd
6: Tx
7: Rx

br gsmcrazy1

[InfinitySupport]

My M1818 PDA set has 2x6 pinout, but the chenese miracle pinout(in latest pinout) has it with 2x7 pinout. So what should be the pinout for this set
M1818 (SUPPER LCD & PDA)?

Please help me as soon as posssible.

Hello,
please, see detailed description here:
http://www.gsmhosting.com/vbb/showpost.php?p=2212036&postcount=7

[meisam]

my problem is that I CAN NOT FIND NEW CONNECTORS.Where can i get them?

[.::Zafar Communication::.]

cect 1818
keyboard top, connector_1x12_mini
5: Gnd
6: Tx
7: Rx

br gsmcrazy1

hi

sir did u test pinout because i built the cable with this configuration no success and reverse rx and tx same result could not read the flash see detail below
COM8 selected
Device: Autodetect
Checking data, wait...
advanced flash detection active
Action: read flash
Boot...
Press and HOLD Power button now !
baud autodetection active
error: initialization1 failed: A0
9600
Connecting, wait...
error: boot phase#2/1 failed
Release Power button now !
In case of initial connection problem: on/off "Boot baudrate autoselect" box.
Boot Fail
Finished, time used: 2 sec
Remove/Install battery now

thanks and regards


Zafar Janjua

[ejazkhan9]

cect 1818
keyboard top, connector_1x12_mini
5: Gnd
6: Tx
7: Rx

br gsmcrazy1

RX TX working for me
i used Charging jack as GND

Thx

[IBMOBILES]

RX TX working for me
i used Charging jack as GND

Thx

working 1000% with Charging jack as GND...:D:D:D