View Full Version : menu problem on a virgin microsnapper
monsterpassword
03-28-2007, 19:46
hello, got 1 microsnapper with menu not open problem . can i read flash from i good microsnapper and flash same to phone with problem? is there any other quick way to sort this problem of menu;
kindly let me know.
InfinitySupport
03-28-2007, 21:17
Hi,
I never heard about this kind of software problem.
I think best way: check phone hardware first.
monsterpassword
03-29-2007, 05:09
in i had 2 mircosnapper. i used another box to unlock first and the menu problem started. so i unlock the other one with infinity and no problem. i have flashed the eprom of the good phone in the phone with problem, but no sucess. so i am thinking of flashing the main firmwars. but i am cautious and i want to know if possible. i can also send u flash file of the good one if needed. pls let know
monsterpassword
03-29-2007, 05:27
where can i get the file system; i think this is the problem; phone can make call ;its just that it cannot enter in menu, it say data error config!
InfinitySupport
03-29-2007, 10:16
@monsterpassword
pls, send me backup from good phone to InfinityHelp@yahoo.com.hk and hope today later it will be possible to repair your phone.
monsterpassword
03-29-2007, 14:43
ok file has been sent. if u can prepare good file pls upload it at support.
thanks
InfinitySupport
03-29-2007, 19:28
Hi,
Uploading in support area now: Microsnapper_Main_2004.10.12-VIR-1.00.10.A31.98M.bin
Please, let me know about results.
monsterpassword
03-30-2007, 05:10
Flash: 98E59F00000000
flash: Fujitsu MB84VD23280FA,MB84VD23180FM,MB84VF5F5F4J2 dual 8 Mb
Boot Done
Set baud...
460800
Set baud Done
Check flash...
Check flash Done
Check space...
Check space Done
Check parameters...
Check parameters Done
Erase...
Erase Done
Write...
Write: Firmware
Err: wrong answer[C5]
Err: write #E2
Write Fail
Err:
Finished, time used: 13 sec
Remove/Install battery now !
box is not allowing me to flash the file u sent me. i did tick on firmware only
thks
Flash: 98E59F00000000
flash: Fujitsu MB84VD23280FA,MB84VD23180FM,MB84VF5F5F4J2 dual 8 Mb
Boot Done
Set baud...
460800
Set baud Done
Check flash...
Check flash Done
Check space...
Check space Done
Check parameters...
Check parameters Done
Erase...
Erase Done
Write...
Write: Firmware
Err: wrong answer[C5]
Err: write #E2
Write Fail
Err:
Finished, time used: 13 sec
Remove/Install battery now !
box is not allowing me to flash the file u sent me. i did tick on firmware only
thks
same problem here, i cannot flash with this firmware, anyone can solve this problem?