View Full Version : 6100 Contact Service
mamadafaf
06-21-2007, 23:47
I Have 6100
all processing i try it
full flash, erase, MCU PPM UI SET etc it OK
BUT
this phone always said "CONTACT SERVICE"
HELP ME BRO...
Jr Telecom
06-21-2007, 23:59
Just One of the time plz.......
---------------------
Folowing steps
1)erase phone
2)Select rh-19/3100
3)Full flash with cnt(6.31v)
_______________________________________
Not yet HDR
mamadafaf
06-24-2007, 00:50
Rh-19 ???
Ok bro.. i'll try it..
Thq a lot
Ma'assalamah
y_info2004
06-24-2007, 01:09
yesyesyes good way realy it works tested by me thanks irtel ctg
mamadafaf
06-24-2007, 19:46
Just One of the time plz.......
---------------------
Folowing steps
1)erase phone
2)Select rh-19/3100
3)Full flash with cnt(6.31v)
_______________________________________
Not yet HDR
MASTER...
My 6100 still CS,
I''m following urs procedure..
Flashing Full with 631ver -> ALL Done
Jr Telecom
06-24-2007, 19:58
MASTER...
My 6100 still CS,
I''m following urs procedure..
Flashing Full with 631ver -> ALL Done
Thanks brother..
Actually CS problem come out from this UEM/PA.
If possible try 2 replace. or remove pa temporalily.
_________________________________________
All the best.
chienchien
06-30-2007, 07:36
:mad::mad::mad::mad:I Have 6100
all processing i try it
full flash, erase, MCU PPM UI SET etc it OK
BUT
this phone always said "CONTACT SERVICE"
HELP ME BRO...
mahavir_compu
06-30-2007, 07:52
try t0 flash phone using charger plug in
try this u will get good result
manishjoshi_bkn
06-30-2007, 08:14
IF AFTER FLASHING CS NOT SOLVED IN DCT4 SETS THEN THE ONLY GUARENTEED SOLUTION IS TO REBALL & THEN CHANGE UPP. IT WILL REALLY WORK FOR YOU BUT IN SOME RARE CASES YOU HAVE TO REBALL UEM BUT IT'S VERY RARE CASE:rolleyes::rolleyes:
aamirgsm
07-01-2007, 09:29
thanks bro my problem is solve................
mamadafaf
07-01-2007, 19:06
Thank's to all my bro, master.
NOW - The fone is NORMALLY after reball UEM and flash full to RH-19 / 3100 - Thank's a lot - Sukrooon Katsiron
HERE THE BEST :rolleyes:
.:Towhid:.
07-01-2007, 22:31
IF AFTER FLASHING CS NOT SOLVED IN DCT4 SETS THEN THE ONLY GUARENTEED SOLUTION IS TO REBALL & THEN CHANGE UPP. IT WILL REALLY WORK FOR YOU BUT IN SOME RARE CASES YOU HAVE TO REBALL UEM BUT IT'S VERY RARE CASE:rolleyes::rolleyes:
Thankyou for usefull information.
cal_wanted
07-16-2007, 11:37
i got same problom..... i reball uem...... but now can't on at all......
:)try to erase flash then flash with higher version...if not u must change UEM mate..:rolleyes:
GsmMunna
07-17-2007, 22:48
Is any One Check Ir Working Fine ???