World Tel A828 Error

[sahil2000ind]

COM6 [VCP0] selected
Device: Autodetect 6205-6227 NOR
Checking data, wait...
advanced flash detection active
Action: read NOR flash
Boot...
Press and HOLD Power button now !
baud autodetection active
19200
Connecting, wait...
error: boot phase#2/1 failed
Release Power button now !
in case of initial connection problem: on/off "Boot baudrate autoselect" box.
Boot Fail
Finished, time used: 4 sec
Remove/Install battery now !





WHEN FORMAT FFS IT SHOW


COM6 [VCP0] selected
Phone should be Switched OFF !
Press and HOLD Power button now !
19200
error: boot phase#2/2 failed
Can't initialize test mode !
Possible reasons:
1. communication fault, repeat required operation
2. eeprom serious damaged, use repair eeprom files or use other unlock/format method
Operation failed !
Finished, time used: 9 sec
Remove/Install battery now !



IS IT A CABLE PROBLEM OR HARDWARE

[InfinityHelp]

hello!

if this is working phone- must be cable problem.
do you push and "HOLD" power button all the time while phone booting?

[sahil2000ind]

hello!

if this is working phone- must be cable problem.
do you push and "HOLD" power button all the time while phone booting?

THE PHONE IS WORKING
I HAVE TRIED IT IN ONE ANOTHER BOX THE CABLE IS CONNECTING THE BOX AND THE SET BUT THE BOX DON'T SUPPORT THIS MOBILE.

[InfinityHelp]

hello!

do you push and "HOLD" power button all the time while phone booting?

[sahil2000ind]

ya have done that also

[InfinityHelp]

one more idea:

you said you tried this cable on another box and it worked:
maybe that box have different RJ45 pinout?

[sahil2000ind]

Bro The Pinouts Of This Box Is Same As Ures

I Have Tried It Too Many Times But No Sucess

I Have Inverted The Rx And Tx Also

[InfinityHelp]

hello!

is this MT procesor based phone?

[RUVAIZ]

brother see if points are given on pcb

[RUVAIZ]

i have one a828 see if it is same