plz help me Infinity support

[ahmad awad]

plz help me Infinity support

plz i need pinuot for this model




thanks for u

[InfinitySupport]

Due to a lot of different models with the same name but absolutely different hardware,
bottom connectors and different pinouts we recommend you to include the next info:
1. detailed description of model
2. phone CPU chip name
3. phone PCB photo (Rx/Tx/Gnd test-points may exist on phone PCB)
4. attach phone photo
5. attach phone bottom connector photo
6. include information about Gnd and Charge pins on phone bottom connector

After you have this information prepared, check the next detailed description how to get pinout for your model:
use "Cable Selector": http://forum.gsmhosting.com/vbb/showthread.php?t=398297
if not helps, please read: C:\Program Files\InfinityBox\pinout\ChineseMiracle\
if not helps, please read: http://www.gsmhosting.com/vbb/showpost.php?p=2212036&postcount=7
if not helps, please read: http://www.gsmhosting.com/vbb/showthread.php?t=433447

[enzawigroup]

infinity team help
i havenokia bluetooth phone the bord same ztc zt199 i finde rx and tx and gr

when i get info with phone on the box read the info
when i wanna to format ffs hi tel me



COM8 [VCP4] selected
Phone should be Switched OFF !
Press and HOLD Power button now !
19200
error: boot phase#2/1 failed
Can't initialize test mode !

i need help
Possible reasons:
1. communication fault, repeat required operation
2. eeprom serious damaged, use repair eeprom files or use other unlock/format method
Operation failed !
Finished, time used: 6 sec
Remove/Install battery now !

[InfinitySupport]

You have used wrong pinout, use correct pinout. You must use Rx/Tx/Gnd but not USB cable.

[mandu]

@ enzawigroup

[B]COM8 [VCP4] selected
Phone should be Switched OFF !
Press and HOLD Power button now !!!!!!!!!!!
19200
error: boot phase#2/1 failed
Can't initialize test mode !




don't release the power button , release when phone begain to start ( test mode) ..