View Full Version : Dubao pinout not working???????????
hassan35278
11-06-2007, 19:59
on the board above Memory card holder
there is 4 dots:
1 2 3 4
Gnd Rx Tx
i did exatly what it dos say on the new pin out seem not working please infiity team chek
tx
hassan35278
11-06-2007, 20:22
forget to say is dabao 758
tx
InfinityHelp
11-06-2007, 20:32
hello!
phone RX must be connected to box TX
phone TX must be connected to box RX
InfinitySupport
11-06-2007, 20:34
It's not important is it Dubao 758 or other model.... You even can write "just a Chinese phone", no need to write exact model name.
I have 2 advices:
Advice #1 (easy): try to swap Rx/Tx wires
Advice #2 (complicate):
Due to a lot of different models with the same name but absolutely different hardware,
bottom connectors and different pinouts we recommend you to include the next info:
1. detailed description of model
2. phone CPU chip name
3. phone PCB photo (Rx/Tx/Gnd test-points may exist on phone PCB)
4. attach phone photo
5. attach phone bottom connector photo
6. include information about Gnd and Charge pins on phone bottom connector
After you have this information prepared, check the next detailed description how to get pinout for your model:
use "Cable Selector": http://forum.gsmhosting.com/vbb/showthread.php?t=398297
if not helps, please read: C:\Program Files\InfinityBox\pinout\ChineseMiracle\
if not helps, please read: http://www.gsmhosting.com/vbb/showpost.php?p=2212036&postcount=7
if not helps, please read: http://www.gsmhosting.com/vbb/showthread.php?t=433447
hassan35278
11-06-2007, 20:54
this is exatly what i did but please and 4 the record dont update ur pinout based on someone said is ok
http://www.gsmhosting.com/vbb/showthread.php?t=437593&highlight=dubao+758
Chandreshswami
11-23-2007, 08:20
on the board above Memory card holder
there is 4 dots:
1 2 3 4
Gnd Rx Tx
i did exatly what it dos say on the new pin out seem not working please infiity team chek
tx
1 = GND
2
3 = RX
4 = TX
LEAVE 2nd
CHANDRESH