PDA

View Full Version : K610 Red Light, And Won't Communicate With Pc!


sia_26
11-25-2007, 17:03
I got a k610 that blinks red when I try to turn it on. I know it's EROM problem, but when I try to make it communicate with the PC it blinks red!!! I'm using Cruiser cables! I've been reading other posts about the same problem, but all could make the phone communicate with cruiser cables.

Help someone?

Sia

ahmertelecom
11-25-2007, 22:55
resold charging components it will be ok

mansi
11-25-2007, 23:33
use 3v power supply and put the + on phones - and the power supply`s - to phones + for few seconds, and try to connect the phone again.

sia_26
11-26-2007, 20:42
use 3v power supply and put the + on phones - and the power supply`s - to phones + for few seconds, and try to connect the phone again.

can i use a 3v battery, and two wires?

S.L.F.
11-26-2007, 22:43
Yes you can use piecies off wire on a 3 volt battery, just connect the wrong way round for a couple off seconds.
This phone may have its security values Knackered, this also gives RED flashing,
Try to ignore the solder option, very unlikely.........

sia_26
11-27-2007, 00:55
Thank you all for the replies! I took the BST-37 battery (3.6v) took a wire on the + and a wire on the -, and connected the + on the battery to the - on the phone, and the - on the battery to the + on the phone. I held it in 10 seconds, then I opened XS++, tapped connect, plugged the cruiser in, and then it said, would you like to upgrade your EROM to CID52, tapped Yes, and then VOILA it worked!:D Thanks to all of you!:D

adnanskyland
11-27-2007, 22:31
I got a k610 that blinks red when I try to turn it on. I know it's EROM problem, but when I try to make it communicate with the PC it blinks red!!! I'm using Cruiser cables! I've been reading other posts about the same problem, but all could make the phone communicate with cruiser cables.

Help someone?

Sia

try to use dummy battery which is present with cable and then flash erom file.

minda69
12-08-2007, 13:56
i was use stable power and put on3.7 V reverse ways of charging + and - on batery contact . after that use ufs setool only press recovery . erom upgrade ok . and voila phone work.

sia_26
12-08-2007, 14:19
I did that to if you read my post. My phone is working already.

gsmsky
12-09-2007, 00:17
upgrade eerom only :d,masi u can recovery phone???? :D

07heaven
12-09-2007, 00:22
Alternatively, take phone apart, and short the internal battery