Alcatel 511 have protected flash zone?

[valmo]

I read full flash (4Mb) from Alcatel 511 with "BF4 Workshop by OmegaGSM". I think, correctly.
After, i unlock it flash with "Alcatel BF3/BF4 Unlocker by Henrich SGU".
Then i write full unlocked flash with "BFx Alcatel Service by AnjelGsm". (so slow - 40 min.)
Finally phone not working.

I write original backup with "Alcatel BF Unlocker v1.08 by GSMFORUM" - in final part of flashing program dont flash some zones.

I read again full flash from phone with "BF4 Workshop by OmegaGSM".
I compare original backup and this backup - some differences in the end.

I think, it's a protected flash zone. May be? If it's really, haw i can write full flash from other phone (if my backup even so bad) an write my eeprom?

[Invisible]

hi,

sorry to say this, as far as I know Omega Flasher works only up to 2megs flashes, so you backup is wrong, that´s why program is not doing the job.
If you have eeprom backed up you could upload same flash and overwrite e2p zone, I think this could fix phone, but not sure if there is other security zones...

best regards,
Invisible

[V.S@]

Yes, that´s right, the flash backup must have 2MB (only flash), or 2,048 kb wich is the full flash backup (flash+eeprom).If you had readed some post´s before you start flashing your phone, you should know that sometimes Omega flasher don´t read the flash very well, and then when you upload it into the phone, the phone doesn´t work anymore.Now you can only try to upload some good flash, and prey for it work´s.



then say something :)

[angele]

Some news about unlocking 511 ???