View Full Version : Totaly dead BF3 101 kj133 after angelo 1.2
Today I managed to unlock a bf3 101 kj133.
-I've made a backup of simlock zone (65ko)
-I've made a backup of eeprom zone (384ko)
When I pushed unlock , the soft read the flash , found simlock data at adresse 4xxx , write the flash .
Now the phone is dead , and I can't connect it anymore.
My cable is working because I can still read 2 other 101 kj133 , make backup and so on.
My problem is to get connected then restore simlockzone from my backup.
Another problem :the full flash write seem to not working , all the time it give " device not open".
Any help ?
doctorvatson
06-29-2002, 06:25
0 output battary from phone
1 run soft
2 connect powered cable to pc
3 connect cable to phone
4 insert battary in phone
5 push "connect" button
it seems to me this soft make bad backup...or can't write it back correctly.
I tried many times save these two zones and then rewrite it to phone---I never got live phone
In my case I made full backup with Omega before...phone live.
try charge battary, check cable and always use external power.
You also can repair with full flash from another phone with the same version, but imei will change
it happened to me too, and thatīs because the backup is corrupted, now it dosenīt mether how many times i write the flash into the phone, that it will never power on again, and you are the one that could save me, please go into this site and download Angelgsm2002 software.
www.******.com
then make a full flash backup from one good Alcatel bf3 311, and then please, send it to me, for i try tosave my 311.I try to do it, then i tell you if it workīs ok?? Iīm hasking for a 2 MB flash more about a week, and until now nobody helped me.
my mail v.s@netc.pt
thankīs ;)
FRANCK13
06-29-2002, 11:44
check your mail.
i send you a full backup : bf3 101kj133
bye
ghettosuperstar
06-29-2002, 16:34
Send it to me please too...
My version is 102_KJ143 and its dead too...
ghettosuperstar@aeiou.pt
I'm just looking for a good flasher to full flash my BF3.
Wich flasher is good to do it.
Omega BFx flasher is fine for flashing...
I nead beckup for my alcatel bf3 101 kj133
If you want, please send me your.
Thank you!
nesadra@ptt.yu:cool:
Hi all,
I have made a full flash backup for a ver 101. kj133110 with alcatel BF Unlocker - Lite version by Bekos Brothers.
After that I haev unlocked the flash with Henrich .
The phone is dead even with the backed up flash uploaded.
Please send me a good flasher and a flash backup for it
airboy@airboy.ro
Thanks
ruboroolz
07-05-2002, 20:46
Hello
Send it to me please too...
My version is 102_KJ143 and its dead too...
I am from spain.
Thanks.
RuBo.
Ruben79@ono.com
HI ALL!
It's very important to use external power and for OMEGA FLASHER this pinouts: 1,2,3-gnd, 4 and 5 and for BEKOS BROTHERS,WRAY,ANGELO use this:1-gnd,2and 3 shorted,4-TX,5-RX.
AND VERY IMPORTANT IS FULL BATERRY AND GOOD CONECTOR,BECAUSE IF U DON'T HAVE FULL BATTERY AND MAKE BACKUP THE PROGS WILL MAKE WRONG BACKUP AND AFTER U WANT TO PUT IN PHONE U WILL PUT SOMETHING WRONG!!!
What all u can do now is to cut from flash eeprom zone put another good flash same version and than put eeprom back!!!
My best regards to all!
Hi,
I have written the flash backedup with BekosBorthers and unlocked back to the phone with Omega Flasher and.... surprise! The phone is alive! And unlocked! The cable used is the same for Bekos and Omeda too, 1 gnd, 2-3 shorted and connected to max232 and to RTS serial pin 7. So , Bekos software reads very well but doesn't write correctly to the phone. Use Omega to rewrite unlocked flash! Enjoy
Hi to all!!!
Yes it's true that lite version have some bugs on writting but ALWAYS WORKING WITH FULL BATERY, but if u want FULL VERSION WITHOUT BUGS read,writte flash eeprom,fast safe backup for eeprom,safe unlocking read,writte language,u can contact me at messenger cosmin44@yahoo.com or icq: 149039664. It's the cheapest price from market!(50usd),with full suport!!!!
contact http://groups.yahoo.com/group/romanian_gsm_solution_free4all/files/Software/ALCATEL/BFuNlockerv1.8.bmp
ps:for omega flasher if u don't have erorr use 1,2,3-GnD,4and 5
My best regards to all!!!!
cosmo
Hi friends!
Please send to me good flash to Alcatel 311 BF3; MCU-102; SUB-KJ143110; FLASH ID-BF31W-1HD1DE.
Thanks & regards
MPS